It is possible to specify a timing gap between consecutive emission on
the same network card through the \b network/sender_gap item. This
is still under investigation as of writting, and the default value is
-to wait 0 seconds between emissions (no gap applied).
+to wait 10 microseconds (1e-5 seconds) between emissions.
\subsubsection options_model_network_asyncsend Simulating asyncronous send
- Any SimGrid-based simulator (MSG, SimDag, SMPI, ...) and raw traces:
\verbatim
---cfg=tracing:1 --cfg=tracing/uncategorized:1 --cfg=triva/uncategorized:uncat.plist
+--cfg=tracing:yes --cfg=tracing/uncategorized:yes --cfg=triva/uncategorized:uncat.plist
\endverbatim
The first parameter activates the tracing subsystem, the second
tells it to trace host and link utilization (without any
- MSG or SimDag-based simulator and categorized traces (you need to declare categories and classify your tasks according to them)
\verbatim
---cfg=tracing:1 --cfg=tracing/categorized:1 --cfg=triva/categorized:cat.plist
+--cfg=tracing:yes --cfg=tracing/categorized:yes --cfg=triva/categorized:cat.plist
\endverbatim
The first parameter activates the tracing subsystem, the second
tells it to trace host and link categorized utilization and the
smpirun -trace ...
\endverbatim
The <i>-trace</i> parameter for the smpirun script runs the
-simulation with --cfg=tracing:1 and --cfg=tracing/smpi:1. Check the
+simulation with --cfg=tracing:yes and --cfg=tracing/smpi:yes. Check the
smpirun's <i>-help</i> parameter for additional tracing options.
Sometimes you might want to put additional information on the trace to
