my_simulator --cfg=Item:Value (other arguments)
\endverbatim
-Several \c --cfg command line arguments can naturally be used. If you
+Several \c `--cfg` command line arguments can naturally be used. If you
need to include spaces in the argument, don't forget to quote the
argument. You can even escape the included quotes (write \' for ' if
you have your argument between ').
within that tag, you can pass one or several \c \<prop\> tags to specify
the configuration to use. For example, setting \c Item to \c Value
can be done by adding the following to the beginning of your platform
-file: \verbatim
+file:
+\verbatim
<config>
<prop id="Item" value="Value"/>
</config>
It is possible to specify a timing gap between consecutive emission on
the same network card through the \b network/sender_gap item. This
is still under investigation as of writting, and the default value is
-to wait 0 seconds between emissions (no gap applied).
+to wait 10 microseconds (1e-5 seconds) between emissions.
\subsubsection options_model_network_asyncsend Simulating asyncronous send
If you want to push the scalability limits of your code, you really
want to reduce the \b contexts/stack_size item. Its default value
-is 128 (in Kib), while our Chord simulation works with stacks as small
-as 16 Kib, for example. For the thread factory, the default value
+is 8 (in MiB), while our Chord simulation works with stacks as small
+as 16 KiB, for example. For the thread factory, the default value
is the one of the system, if it is too large/small, it has to be set
with this parameter.
